Может проще сканером прописать новый брелок в ЦЗ? Не?
Так их модуль ЦЗ не имеет K-линии или какого другого интерфейса:
повороты ключа в замке вызывают одно загорание ламп и второе через 10 сек
По инструкции из мануала нужно любую кнопку на ключе давить 10 секунд:
Open the door and turn the key continuously and quickly from LOCK position to ON position 5 times
and finally turn it to ON position, and at this time the turn signal lamp flash once, which means the
learning function is activated. Press any button on the remote controller within 10 seconds, and the
turn signal lamp would flash twice, which means that the remote controller is successfully registered.
Such operation can be repeated and up to two remote controllers can be registered; the system would
exit from the learning function if no remote controller is pressed in 10 seconds. The first registered
remote controller would be cleaned when registering a new one after two remote controllers are
registered.
Всего два ключа запоминаются, третий вытолкнет из памяти первый.
P.S. Даже "старый" Блок ЦЗ умел блокировать двери на скорости и закрывать все окна.